Xirlink X9901 User Manual - Taking A Picture
3
6. Lo: battery low
cause: battery voltage below the threshold
result: may cause picture worse quality (try new battery)
7. LL: low light condition
cause: no enough lighting
result: longer exposure time and may have noise within the picture
8. --: enter testing mode
cause: press both buttons while power up
result: start testing routine after release both buttons
9: FO: verify flash OK
cause: test flash OK when enter testing mode
result: enter button testing routine
10. b1: testing shutter button
cause: push shutter in testing mode
result: LED flash once and buzzer beep once
11. b2: testing self-timer button
cause: push self-timer in testing mode
result: LED flash twice and buzzer beep twice
Taking a Picture
1. Turn the camera on
Note: The camera will go to a Standby mode if you
don’t take a shot in 10 seconds.
2. Frame the subject through the optical viewfinder
Note: The distance between you and the subject(s)
can range from 3 feet to infinity
3. Press the shutter button to take the shot
Note: Press and hold the button until you hear a beep