XM Controls Tandem-Wire Operation Manual - page 9
3. Observe all Safety Lines and Limits at all times.
4. Wear appropriate safety gear when operating any function of this equipment.
5. If a malfunction occurs:
A. Shut down the entire system.
B. Contact the system manager immediately.
6. If the standard system motion becomes obstructed, DO NOT ATTEMPT to clear the obstruction
yourself. Follow procedures described in #5.
7. Shortcuts can cause serious injury or death and may damage the system.
8. In all situations THINK before you act.
Principal Safety Standards
Safety in Welding and Cutting, ANSI Standard Z49.1, from American Welding Society, 550 N.W. LeJeune
Rd, Miami FL 33126
Safety and Health Standards, OSHA 29 CFR 1910, from Superintendent of Documents, U.S. Government
Printing Office, Washington, D.C. 20402
Recommended Safe Practices for the Preparation for Welding and Cutting of Containers That Have Held
Hazardous Substances, American Welding Society Standard AWS F4.1, from American Welding Society,
550 N.W. LeJeune Rd, Miami, FL 33126
National Electrical Code, NFPA Standard 70, from National Fire Protection Association, Batterymarch
Park, Quincy, MA 02269
Safe Handling of Compressed Gases in Cylinders, CGA Pamphlet P-1, from Compressed Gas Association,
1235 Jefferson Davis Highway, Suite 501, Arlington, VA 22202
Code for Safety in Welding and Cutting, CSA Standard W117.2, from Canadian Standards Association,
Standards Sales, 178 Rexdale Boulevard, Rexdale, Ontario, Canada M9W 1R3
Safe Practices For Occupation And Educational Eye And Face Protection, ANSI Standard Z87.1, from
American National Standards Institute, 1430 Broadway, New York, NY 10018
Cutting And Welding Processes, NFPA Standard 51B, from National Fire Protection Association,
Batterymarch, Quincy, MA 02269