Xomax XM-2DTSBN706 Instruction Manual - page 9
14
07
Instruction for the operation of touch screen
4.4 Audio setting
Audio setting mainly includes setting for: [SUB] for control Sub woofer ON/OFF,
[MBP] can select listening position for left/right or off , [LOUD] for control loudness
ON/OFF , [CAMARA VOL] for setting reversing the speaker output ON or mute ,
presetting equalizer==>[EQ] for select POP->ROCK->CLASS->JAZSS four preset
EQ mode or OFF, [DOUB ZONE] for control double zone ON/OFF with GPS sound .
4.5 Video setting
Video setting mainly includes setting of high-width ratio, brightness adjustment,
contrast adjustment, adjustment of color saturation and tone adjustment, etc.
4.6 Radio setting
Radio setting mainly sets the radio region and selects different regional standards in
different regions.
Instruction for
the
operation of touch screen
10.3 GPS map interface
10.2.3 If the original path has been set, not canceled, but much be set a new starting
point: first "DeleteRoute" (see above section 2) by deleting the newly planned path,
and then the above steps to re-set a new starting point for planning new the path.
9.2. 2 Or start the simulation: In step 1 from the end of the path planned basis points
into the lower right corner of map "Menu" --- New menu top right corner of "Route" in
------- below the "FLYOVER" is fast simulation (no sound), and lower right of the
"Simulate" is a normal simulation (sound), and "Delete Route" is to delete just set the
path, "Itinerary" is planned path information and so on.