XP Metal Detectors ADX150 Wireless Ready Instruction Manual - page 6
5
A S S E M B L Y
The assembly of your detector will only take you
a few seconds.
Put the shaft together as shown on the diagram.
x Put the rubber washers on the side
of the fibreglass tube (1).
x Insert the fibreglass tube on the
search head (2).
x Insert the new coil fixing parts as shown
x on the diagram and screw (3).
The electronic box of your detector can be positioned in 2 different ways:
Option 1 : Under the armrest
To fix it, insert the 2 wings of
the armrest in the slides of the
electronic control unit, as
indicated on
the diagram.
Once the control box in place
under the armrest, wind the cable around the telescopic shaft as
indicated on the photo.
Use the 2 pieces of Velcro® (A and B) to keep the cable in a spiral
position.
Insert now the
connector
(female) in its
panel connector
(male), screw it,
the connector is
now watertight.
3
m.
n