Xpand X105-RF-X1 User Manual - Attention – Consult
© XPAND, All Rights Reserved.
4
www.xpand.me
Using with 3D TVs
1. Connect the emitter connector to the corresponding VESA stereo connector in the
TV or projector.
2. Once the emitter is connected to the TV/projector, please make sure that the TV/
projector is in 3D mode. Check the X sign on the emitter; the red light should be on,
indicating that the emitter is functioning.
3. For maximum range emitter should not be placed on the ground/floor but should
be placed at least 10cm above ground (like on a shelf).
The emitter does not require a battery.
Troubleshooting
The emitter is connected but the glasses still do not work: Please make sure that
your glasses are turned ON and that your TV/projector is in 3D mode. If problem
persists try unplugging the emitter for a couple of seconds and then plug it back in
the corresponding VESA stereo connector in the TV/projector.
Technical Specifications
Weight: 2.72 oz (77 g)
Power Supply: via standard stereoscopic VESA connector
Operating Temperature: 5 °C (41 °F) – 40 °C (104 °F)
ATTENTION – Consult
Accompanying Documentation
Important Safety Instructions
» Read these instructions.
» Keep these instructions.
» Heed all warnings.
» Follow all instructions.
» Do not use this apparatus near water.
» Clean only with dry cloth.
» Only use the attachments/accessories specified by the manufacturer.
manual-X105-RF-X1-xpand.indd 4
28.9.2012 9:51:25