Xpand X105-RF-X1 User Manual - page 4

© XPAND, All Rights Reserved. 

2 

www.xpand.me

This procedure shall be followed every time the glasses are introduced to a new  3D 

host. During the proximity association, the 3D glasses shall be located within 3ft (1m) 

from the 3D host (3D TV, 3D Emitter…).

» Turn on the glasses. 

» LED (2) will light up from off to bright, indicating the glasses are  turned on.

» Press button (1) for at least 1 second.

» After 1 second, the LED (2) will start to blink with a rate of 1 blink per 2 seconds. 

» Release button (1).

» Successful proximity association is indicated with 6 short LED (2) blinks.

» If the glasses could not associate with the 3D host, the LED (2) will dim from 

bright to off and glasses will turn off.

Connecting Your Glasses to 3D Host

Once the glasses are associated with the 3D host, they will automatically connect 

to that host every time they are turned on. In case the glasses lose the connection 

with the 3D host  during operation, they will automatically try to reconnect to that 

host (LED (2) is blinking with a rate of 1 blink per 2 seconds). If the glasses cannot 

successfully reconnect to the 3D host within 60 seconds LED (2) will dim from bright 

to off and the glasses will automatically turn off.

Set Glasses to Operate in Dual View Mode

With the selection of Dual View Mode, the XPAND 3D Glasses Lite can be used for 

dual gaming. Dual View Mode can be used during normal 3D viewing as well to 

disable 3D viewing for people that face an uncomfortable feeling when watching 3D.

When the 3D host is emitting the dual view signal, double click on button (1) to 

change Dual View Mode between player 1 and player 2. 

Not all 3D host devices support a dual view signal. When the 3D host is emitting a 

normal 3D signal, double click on the button (1) to change between player 1, player 

2 and normal 3D viewing mode.

When a double click is detected, the LED (2) will indicate the eyewear mode:

Player 1: One Quick Blink

Player 2: Two Quick Blinks

Normal 3D*: One Long Blink

*Accessible only if the 3D device is not emitting dual view signal.