1 xpelair low energy wall/window fan range for use with rf switch gx6 ec3 rf gx6 ec3r rf installation and maintenance instructions retain for future reference.
2 a d c.
3 e1 e2.
4.
5.
6.
7 xpelair ultra gx6 ec3 rf and gx6 ec3r rf installation and operating instructions please leave this leaflet with the fan, for the benefit of the user. The ultra gx6 ec3 rf models have the following features: window / wall / panel / roof mounting options. For rf switch operation. Intake and extract ...
8 the switch location (in the wall or above the ceiling). 2. Lay in the cable from the isolating switch to the fan location. 3. Lay in the cable from the isolating switch to the point of connection to the mains supply. Warning: do not make any connections to the electricity supply at this stage. 4. ...
9 6b. If wiring from above, remove the fan’s electrical cover and feed the cable through the top cable entry. 7. Hold the fan assembly to the inside of the wall so that the spigot is inserted into the wall duct. 8. Mark the position of the two fixing holes in the top left and bottom right corners. 9...
10 a qualified electrician must carry out all cleaning. Note: the fan will continue to operate with the inner grille removed hence it must be isolated completely from the mains before any work is carried out. 1. Before cleaning, isolate the fan completely from the mains electricity supply. Allow 3 m...
11 this page has been left blank for the addition any notes you may wish to make..
12 guarantee terms and conditions for uk & roi (outside uk & roi contact your local distributor) n the unlikely event of a product breakdown during the guarantee period you should contact our service and repair helpline who will be able to assist with the repair and advise the best course of action ...
