Xpelair GX6 EC3 RF Installation And Maintenance Instructions Manual - page 10
10
A QUALIFIED ELECTRICIAN MUST CARRY OUT
ALL CLEANING.
NOTE: THE FAN WILL CONTINUE TO OPERATE
WITH THE INNER GRILLE REMOVED HENCE IT
MUST BE ISOLATED COMPLETELY FROM THE
MAINS BEFORE ANY WORK IS CARRIED OUT.
1.
Before cleaning, isolate the fan completely
from the mains electricity supply. Allow 3
minutes for the impeller to stop rotating
and the powered shutter to close.
2.
Remove the back draught shutter/grille
assembly by pressing the release catch
located on the side of the unit with a 6mm
screwdriver or a coin, whilst pulling the grille
forward. To remove the back draught shutter,
lay face down and pull the shutter forwards,
see Fig. G1 and Fig. G2.
3.
To remove the impeller, unscrew the central
screw with a 7mm nut runner and remove it,
place the screw to one side.
4.
To clean the impeller, either wipe it with a
damp, lint free cloth or wash it in warm soapy
water. Do not use strong detergents or
chemical cleaners.
Thoroughly dry the
impeller and refit. Replace the screw ensuring
that it is securely fitted.
5.
Clean the back draught shutter and grille in
warm soapy water. Do not use strong
detergents or chemical cleaners.
6.
Thoroughly dry the back draught shutter and
grille and refit the back draught shutter to the
grille by placing into position and pushing
down until it clicks into position, see Fig. G3
and Fig. G4.
7.
Refit the back draught shutter/grille assembly
by sliding the grille back over the release
catches, the catches will locate and secure
the grille.
Do not immerse the fan in water or other
liquids to clean any other parts of the fan.
Never use strong solvents to clean the fan.
Apart from cleaning, no other maintenance is
required.
1.
Back draught shutter.
2.
Fan assembly.
3.
Outer grille.
4.
Ladder strips.
5.
Electrical cover.
6.
Trickle vent catch.
7.
Rear cable entry.
8.
Top cable entry.
9.
Rating plate.
10. Lugs for screw mounting.
11. Grille.
12. Screw hole caps.
13. Actuator lever.
40984SK – Wax Actuator
41004SK - Actuator Linkage Assembly
41010SK – Outer Grille Assembly
41785SK – Ladder Strip Kit 3”
42057SK – Impeller Assembly
42031SK – Inner Grille / Shutter Assembly
42058SK – GX6 EC3 RF Motor/Duct Assembly
42059SK – GX6 EC3R RF Motor/Duct Assembly
Maintenance
Components, Fig. D.
Spares