Xpelair Xpelair C100T Installation And Maintenance Instructions Manual - By Children.
[4]
Xpelair C100P / C100T / C100HT
Contour Range of Toilet / Bathroom Fans
Installation and operating instructions.
Please leave this leaflet with the fan for the benefit of the user.
IMPORTANT CUSTOMER INFORMATION
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning the use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and maintenance of the appliance shall not be made
by children.
Before any cleaning or maintenance, isolate the fan completely
from the mains supply.
These appliances are intended for connection to fixed wiring.
Check that the electrical rating shown on each fan matches the mains supply.
A means for disconnection in all poles must be incorporated in the fixed wiring. All installations must be
supervised by a qualified electrician. Installations and wiring must conform to current IEE Regulations
(UK), local or appropriate regulations (other countries).
If you have any queries before installing these products or after they have been installed, call the
Xpelair Technical Hotline +44 (0) 844 372 7766. Our engineers are there to help you during normal
office hours (UK only) and may be faxed at all other times on +44 (0) 844 372 7767.
Customers outside the UK should contact your local Xpelair distributor.
Description.
All Contour fans have the following features:
Single speed extraction
Built-in back draught shutter
C100P
- Operate the fan using an integral pull-cord.
C100T
- Built-in timer operates fan for a preset delay of up to 30 minutes.
C100HT
- Operates when triggered automatically by the humidity sensor, using an external on/off switch or using the
integral pull cord switch.
In automatic mode: the built-in timer automatically operates the fan for a pre-set delay time of up to 30
minutes once humidity drops below the pre-set Relative Humidity (RH) value.
In manual mode: when the fan is switched off, it goes into automatic mode.
External operation: The fan can be set so that there is a 2-minute time delayed start to its operation when
used with an external on/off switch. When switched off using the external on/off switch the fan continues to
run for the preset delay of up to 30 minutes.