Summary of PRO
Page 1
Quick start guide for using xplorer 3d pro.
Page 3: Welcome Xplorers!
Welcome xplorers! This the quick start guide for using your xplorer 3d pro you can find updated versions of this guide on our website, at www.Xplorer3d.Com , where you can get in touch with customer service if you have any questions..
Page 5: Index
Index 1. Safety information 2. Technical specifications 3. Unpacking and installing xplorer 3d pro.
Page 6
The current state of 3d desktop art technology even though the only real limit is your own creativity, current 3d printing technology also has its limits. You can find out what they are by reading our 3d modeling directives document (https://www.Xplorer3d.Com/blogs) the most relevant aspect to guara...
Page 7: 1. Safety Informaton
1. Safety informaton.
Page 8: 1. Safety Information
1. Safety information even though the xplorer 3d pro printer was designed to be as safe a piece of equipment as possible, we wish to remind you it was conceived for use by adults. Still, there are safety concerns you must keep in mind: 1 - adult supervision: because we can never stress this enough, ...
Page 9: 2. Technical Specifications
2. Technical specifications.
Page 10: 1. Technical Specifications
1. Technical specifications printing technology fff max. Printing volume 200mm x 200mm x 200mm [7.9” x 7.9” x 7.9”] layer resolution high - 100 micron low - 300 micron filament diameter 1.75mm volume 40cm x 40cm x 45cm approx. Weight 16.5kg [36.3lb] working ambient temperature 15º - 30º c storage te...
Page 11: 3. Unpacking and Installing
3. Unpacking and installing xplorer 3d pro.
Page 12
1. Open the box and remove the printer‟s protective material. 2. Remove the printer by holding the top frame 3. Carefully remove the protective packaging . 4. Check to make sure the box contains the following items: 1 xplorer 3d pro 1 printing bed‟s glass 1 tweezers 1 allen key set 1 roll of adhesiv...
Page 13: Xplorer 3D Pro Diagram
Xplorer 3d pro diagram left side filament entry extruder extruder nozzle calibration screws on/off switch led display control buttons print bed sd card mount mini usb.
Page 14: Installing Xplorer 3D Pro
Installing xplorer 3d pro 1. Before you begin, make sure your computer has a working internet connection and that it‟s connected to the mains or has enough charge left in its battery. 2. Next, log on to www.Xplorer3d.Com and download the most recent version of xplorer engine & xplorer 3d drivers for...
Page 15
3. Connect the usb cable to xplorer 3d pro and to the computer. 4. Place one, and only one, layer of adhesive tape on the printer bed glass, carefully to avoid any overlapping. 5. Place the spool inside the spool mount. Take care to keep the filament wound tight, because any looseness might cause ki...
Page 16: How To Print
How to print 1. Make sure you have disabled your computer‟s hibernation or suspend to disk function. If the computer goes into hibernation or suspend to disk state while something is being printed, you will be unable to resume this task and you will have to start again. 2. Make sure the adhesive tap...
Page 17: After Printing
After printing after your print is over, you have to remove the object from the table. Try to do it first gently by hand without damaging it. If you are not able to do it, use something like spatula parallel to the table. If none of these techniques work, remove the tape. Don‟t forget to replace the...
Page 18
© xplorer 3d pakistan. Www.Xplorer3d.Com all rights reserved..