Xpressivo XEMS1 User Manual - Frothing Milk
Frothing Milk
Making your favorite cappuccinos or lattés is easy
with the simple to use steam wand.
Hot water can be dispensed at the touch of a button for
pre-heating cups, making an Americano, or for cleaning.
The indicator light will blink red
while warming up and solid red
when ready to steam.
Tip
#3
Tip
#4
Move the selector knob
to OFF position.
Wipe down the steam wand
immediately with a wet towel and
run the steam for a few seconds.
Turn the selector knob to
the STEAM position.
Press the STEAM button to
start steam and press the STEAM
button again to stop steam.
Always remember to clean your
steam wand immediately after use.
If you see the indicator light flashing
red and blue, turn the selector knob
to OFF
position for five seconds.
Fill a stainless
steel steaming
pitcher 1/4 full
with cold milk.
Steam the milk until
achieving the desired
foam and temperature
(about 65°C or 150°F).
1
3
2
4
Use the rubber tab to avoid
touching the hot wand.
!
The position purges the
steaming wand.