Xray RX8 Instruction Manual - page 20
20
FRONT ANTI-ROLL BAR
FRONT ANTI-ROLL BAR
The front body post has two positions - FRONT and REAR. The
distance difference between these two positions is 2mm. The position
of the front body post depends on the position of the rear body
mount: (Page 12 step 2)
1) INITIAL SETTING: If the shim on the rear body mount is IN FRONT
OF the body mount, place the front body mount in position REAR.
2) If the shim on the rear body mount IS BEHIND the body mount,
place the front body mount in position FRONT.
903410
SFH M4x10
FRONT
REAR
INITIAL
SETTING
27.3mm
BEARING
OIL
342462
FRONT ø2.2mm
OPTION
342464
FRONT ø2.4mm
OPTION
342466 FRONT ø2.6mm
STANDARD
342468
FRONT ø2.8mm
OPTION
FRONT
ANTI-ROLL BARS
DETAIL
902310
SH M3x10
901303
SB M3x3
901304
SB M3x4
940508
BB 5x8x2.5
ALTERNATIVE 1: WIRE ANTI-ROLL BAR
ALTERNATIVE 2: BLADE ANTI-ROLL BAR
ALTERNATIVE 1: WIRE ANTI-ROLL BAR
CENTER
When the upper bumper is installed, set the bar into the center, remove the
play with the bushings, and tighten the setscrews fully.
2x
4. FRONT SUSPENSION
NOTE ORIENTATION
Step detail
Ensure that the suspension arms move freely.
Ensure that the eccentric holders move freely.
When the bars are set, verify that both sides move at the same time. If they
do, the bars are set up correctly. If not, make sure that both downstops are
the same and that the bar wire is flat.
When the bar is set, verify that both
sides move at the same time. If they
do, the bars are set up correctly. If
not, make sure that both downstops
are the same. If the arms still do not
move at the same time, gently loosen
the screw which holds eccentric
bushing and move with the bushing
until the arms do not move same
time. Retighten the screw fully.
If the sides still does not move at the same
time, adjust the length of the bar holders.
Each anti-roll bar blade has a hex hole at its end. Use
a 1.5mm hex wrench to adjust the blades.
FRONT ANTI-ROLL BAR
Do not insert ball into cup too deeply
or bars will bind during operation
3x3
3x3
3x4
3x4