Xray RX8 Instruction Manual - page 23
23
ACKERMANN
6. STEERING
bAG
➊
DETAIL
STEP
3-4mm
4
3
2
1
4
3
2
1
INITIAL PRELOAD
SETTING
INITIAL SETTING
THERE ARE 4 DIFFERENT ACKERMANN SETTINGS POSSIBLE WITH THE QUICK-SAVER™
STEP 1 gives the most Ackermann and makes the car
understeer more into and out of corners. It offers good
cornering speed and creates very good traction mainly
in chicanes, because the car will be more stable.
For tracks with long sweepers where a lot of cornering
speed is needed.
For initial Ackermann setting, use Step 1 (2nd shortest length).
STEP 4 gives the least Ackermann and creates a lot
of steering into and out of corners. However, the car is
more difficult to drive in chicanes because there is less
traction and stability.
For tracks with a lot of in-corner steering needed.
1 STEP OUT
4 STEPS OUT
970100
O 10x1.5
902310
SH M3x10
903312
SFH M3x12
301159-O ALU COUNTERSUNK SHIM - ORANGE (4)
302663 COMPOSITE BALL JOINT 4.9MM - OPEN - V2 (8)
307455 PIVOT BALL 4.9 MM DOUBLE BEVEL SHOULDERS (10)
332561 SERVO SAVER SPRING C=14
332660 COMPOSITE STEERING & SERVO BALL JOINT 5.8 MM (4+2)
333240 BALL UNIVERSAL 5.8 MM HEX (4)
342500 SERVO SAVER COMPLETE SET - V2
342510 COMPOSITE SERVO SAVER
352648 XT8 ADJ. TURNBUCKLE M3 L/R 62 MM - HUDY SPRING STEEL (2)
902306 HEX SCREW SH M3x6 (10)
902308 HEX SCREW SH M3x8 (10)
902310 HEX SCREW SH M3x10 (10)
903312 HEX SCREW SFH M3x12 (10)
940508 HIGH-SPEED BALL-BEARING 5x8x2.5 RUBBER SEALED (2)
970100 O-RING 10 x 1.5 (10)
342500
34251 0
332561
342500
903312
301159-O
342510
307455
333240
902306
940508
902310
970100
940508
302663
352648
352648
902306
902308
333240
332660
902310
BEARING
OIL