Xray T1 Instruction Manual - page 15
STEERING
14
1. Choose the proper servo horn to fit your servo; see the parts list.
Orient the servo horn as shown in the image.
2. Pass a #902310 (SH M3x10) screw through a #307454 pivot ball
and servo link ball joint, and into the hole at the end of the servo horn.
Tighten until the pivot ball snaps into the ball joint, and then tighten
the whole assembly.
Check all servo saver arms for freedom of movement.
1. Press a #302551 eccentric servo saver plastic cover into the corresponding hole in
the bottom of the upper deck. The tab goes to the REAR.
2. Press a #930407 (BB 4x7) ball-bearing into the plastic cover in the top deck.
3. Position the servo saver in the chassis, and slide the steering rods through the front
bulkheads.Place the servo saver lower post into the ball-bearing in the chassis.
4. Attach the alu top deck mounts to the chassis using #904306
(SFH M3x6) screws.
5. Place the top deck atop the bulkheads. The servo saver upper post fits
into the ball-bearing in the top deck.
6. Attach the upper deck to the bulkheads and top deck mounts using
eight #904306 (SFH M3x6) screws.
930407
BB 4x7
LEFT
STEERING ROD
62mm
Splines for servo
on this side
RIGHT
STEERING ROD
60.5mm
SERVO LINK
1. Attach the left and right steering rods to the servo saver.
Pass a #902312 (SH M3x12) screw upward through the following parts:
• #307454 pivot ball
• steering rod inner ball joint (on long end)
Thread the screw into the inner hole on the bottom of the servo saver.
Tighten until the pivot ball snaps into the ball joint, and then tighten the
whole assembly.
2. Attach the servo link to the servo saver. Pass a #902310
(SH M3x10) screw downward through a #307454 pivot ball
and servo link ball joint, and thread into the servo saver side arm.
Tighten until the pivot ball snaps into the ball joint, and then
tighten the whole assembly.
902310
SH M3x10
904306
SFH M3x6
Slide steering rods through bulkheads
FREE MOVEMENT
FREE
MOVEMENT
307454
PB 5 mm
307454
PB 5 mm
307454
PB 5 mm
INITIAL POSITION:
MOUNT STEERING
RODS TO OUTER HOLES
902312
SH M3x12
Attach the left and right steering rods to the steering blocks.
Pass a #902312 (M3x12) screw downward through a
#307454 pivot ball and the steering rod ball joint,
and thread into the steering block outer position.
Tighten until the pivot ball snaps into the ball joint,
and then tighten the whole assembly.
Check the steering system for freedom of
movement.
902312
SH M3x12
902310
SH M3x10
TAB TO REAR
REAR