XTA D2 Operator's Manual - page 2
Page 2
D2 Operators Manual
D2
Quick Reference
THINGS YOU NEED TO KNOW…
ü BOLD
MEANS HOLD!
Any functions that would produce possible
unexpected level changes at the outputs are
protected by a ‘press and hold’ action and
printed in BOLD on the panel. These
functions are:
Changing MODE between ‘cut below’ and
‘cut above’;
Switching middle band into FULL RANGE
mode;
Enabling the sidechain LISTEN function on
any band.
ü
The meters show level, in dB, from the
clipping point of the unit – when the
METER switch is set to ‘IN’ the meters
show level, in dB, from clipping the
input converter. Set to ‘OUT’ they
show headroom available at the output
– the DAC.
ü
When in Shelf mode, the outer bands
only become full range when the Freq
is set to 20k and 20Hz respectively.
ü
Make-up gain is automatically bypassed
when the Master switch is off.
ü
Only one Listen can be active at any
time – selecting another band cancels
the last one.
ü
The Listen LED always flashes when
any Listen switch is enabled. Listen is
not automatically turned off if the unit
is switched off and on.
ü
When the unit is bypassed, all its
metering and status LEDs will dim. All
metering will continue to function.