XTE Electronic HP2150 User manual - page 11
User’s Manual
11 17
13. Advanced Functions - DSP Section
13.1. Programmable settings („Presets“)
The
DSP
combines
numerous
integrated
functions with very simple operation. Even in
acoustically difficult environments, best results are
achieved. So-called „Presets“ can easily be
programmed. No less than 20 of these preset
slots enable programming for any application and
make them available to the user at the touch of
one’s fingertips.
For each preset, the following 3 parameters are
programmed:
•
master volume
•
which of the 2 outputs are to be active
•
preset name.
This way the different settings are immediately
distinguishable.
13.2. Changing between presets
•
Turn the unit on with the main on/off switch
located on the front panel.
•
The welcome message will appear in the
display. After a few seconds, it will disappear
again and the settings of the current preset
will show up. Below, an example is given.
VOLUME -50 -36 -30 -22 -15 -9 -3 0dB 1
PRESET
2
•
Here one can see the current preset name (in
this case „Preset 1“) as well as the value of
the master volume in percent (total output
volume, here 70%). The bar above the preset
name is an analogue representation of the
master volume.
•
On the right-hand side of the display the two
little squares represent the 2 outputs (the
numbers 1 through 2 are written above and
below the display). A dot within a square
indicates, that this particular output is active.
•
Please note: The preset settings can be
guarded against accidental changes. In this
„Vol/Preset protect“, changes can only be
undertaken by pushing and turning a knob at
the same time.
•
In order to switch from one preset to another,
push the preset knob while turning it until the
desired preset shows up in the display; then
let go. Now, all is set for the next application.
13.3. Temporarily changing on existing
preset
•
Should it become necessary to change the
volume of a given preset, turning the volume
knob to set the desired value. This change is
only temporary, i.e. once the unit is turned off
and back on again, the original preset is
active again. Push the volume knob while
turning it to set the desired value if the
„Vol/Preset protect“ is activated.
•
Should it become necessary to temporarily
change the active outputs. By pushing the
preset knob, the display will successively
show each output. The respective name of the
output will appear (in the example given below
„Output1“) as well as a little square next to the
corresponding number of the output. „On“ or
„off“ indicate whether the output is active or
not. This is also reflected in the little squares,
where a dot in the middle indicates an active
output.
VOLUME -50 -36 -30 -22 -15 -9 -3 0dB 1
PRESET
2
•
Turning the volume knob by one click, you
can change the output to „on“ (active) or „off“
(deactivated). Briefly pushing the volume knob
will take you one level back, and in the display
you will see the preset name again with its
current settings. These changes are also
temporary, i.e. will only be effective until the
unit is turned off and back on again.
| Output1
on |
|
|
70 | ...................
|
1 | Preset 1
|