Y-cam Black Quick Installation Manual - 3. Running The Camera Wizard
D. An IP address will automatically be assigned to your camera and displayed in
the box above.
Note: if no camera details are displayed, try clicking “Refresh” Select the camera
you wish to connect to and click “Open”. This will then open up the Y-cam
Homepage in a new browser window,as shown in fig 3.1
4
3. Running the camera wizard
A. Now that you have successfully set up the camera in wired mode, you can access the
camera on your local network by:
Either selecting the camera in the setup ulitlity and clicking “Open” (as you have just
done in Step 2D)
or by typing in the camera’s IP address (as displayed in Camera Setup Fig 2.2) directly
into your Internet Browser’s address bar. For example, if your camera’s IP address is
192.168.1.100, enter “http://192.168.1.100” and you will see the Y-cam Homepage
screen below.
Fig 3.1
Note: Depending on your setup, your IP address may change from time to time.
If you ever need to re-check your IP address use the Setup Utility (fig2.2)
Fig 2.2