Y-E Data YD-8V03 User Manual - page 10
Internal 7 in 1 Drive User’s Manual
149369-02 Rev. A
Page 10
August 2002
5.
5.
5.
5. Before use
If the Internal 7 in 1 Drive is already built before OS is installed, on installation about
Windows 2000, 98, and 98SE, the memory cards are treated as other devices and do not
operate, but this is normal. About Windows XP and Me, removable disk icon is displayed.
•
Before using the Internal 7 in 1 Drive, install the driver software after the USB
Interface disconnect SW is OFF. When adding the Internal 7 in 1 Drive to the PC
equipped with an OS, install the Internal 7 in 1 Drive driver software by starting up its
installer software before building the Internal 7 in 1 Drive hardware into the PC.
•
If the hardware is built in before execution of the installer, when the hardware
wizard appears, be sure to “cancel” the wizard, and then start up the installer. The
floppy disk drive operates with the OS-standard driver, so it is unnecessary to install the
driver software for the FDD.
•
There are four types of driver software: for Windows XP, and for Windows 2000, and for
Windows Me, and for Windows 98, and Windows 98 Second Edition.
[Important]
If an earlier version of driver software or the driver software for our USB Hexa Media
Drive is installed, uninstall it before installing the Internal 7 in 1 Drive driver. The
Internal 7 in 1 Drive driver is compatible with the USB Hexa Media Drive. (Both
operate with the same driver.) For the method of uninstalling driver software, refer
to Paragraphs 6.3 “How to uninstall the driver software.”
6.
6.
6.
6. How to install
6.1.
6.1.
6.1.
6.1. How to install driver software
CD-ROM corresponds to Windows XP, 2000, Me, 98 and 98SE. Insert the driver CD-ROM
into the PC. Then the installer will automatically start up. Installer identifies the OS version,
and starts up the installer software. The procedure of installation on Windows XP is as
follows. The procedure on other OS is almost same.
1) Before starting Windows, confirm the USB Interface disconnect SW of Internal 7 in 1
Drive is OFF.
2) Start up Windows and log in with the user name that is given Administrator privileges.