Yada BT53328 User Manual - page 8
6
11. Replace the light socket back into the reverse light housing.
12. Replace any interior panels that may have been removed to access the taillight and close your trunk
or rear hatch.
13. Standing with the license plate in one hand and the Camera in the other hand, slide the Camera
along the top of the license plate in order to determine the placement. Best placement is in the
center of the license plate. If you have a rear hatch handle you may need to remove the Camera
bracket, turn the bracket upside down and reattach to the Camera. You would then mount the
Camera from the bottom of the license plate.
14. Peel off the lining of the double-sided tape already attached to the Camera and press firmly to the
license plate to secure the Camera. Make sure the back of the license plate is clean before attaching
double-sided tape.
15. Press the license plate and the Camera mounting firmly to the car to secure and get full contact
between the license plate and the double-sided tape. Screw the license plate back onto the rear of
your vehicle.
16. Once license plate and Camera are secure, you can adjust the vertical angle of the Camera to your
specific need.
17. As a last check, note the position of the view from the Camera when you place the vehicle in reverse.
Adjust the angle of the Camera as necessary to achieve the best rear view.
DIESEL INSTRUCTION:
Temporarily connect the Camera following the wiring instructions above. Then check the Camera image
for rolling lines with vehicle running. If there are no rolling lines, permanently install the components
and wiring. If rolling lines occur you will need to run a power wire directly to the battery post instead of
using the reverse lights. Then the power line will need to be cut and run to a switch near the driver so the
Camera can be switched on/off. Without a switch the Camera would drain the battery and possibly burn
out the Camera. Be sure to use a fuse when connecting to the battery post.
Video’s are available on
www.letsyada.com
to see step by step installation instructions.