Yada BT54358-2 User Manual - page 6
4
also watch some common installation videos at www.letsyada.com for more information.
Caution: This unit is designed to operate on a 12V/24V DC NEGATIVE GROUND electrical system.
Connecting to other types of electrical systems will cause damage to your vehicle. Please contact
the manufacturer if you are unaware of the system type in your vehicle.
1. Remove your license plate
2. Determine the best route for the Camera Cable from the top of your license plate to the inside
of the vehicle. You may need to drill a small hole in the panel behind where the license plate is
situated.
3. Take the Camera and run the cable through the Rubber Ring Grommet, then from the outside of
your car to the inside. Pull the cable through so that there is a small amount of slack and you can
still move the Camera around the license plate.
4. Locate the reverse taillights wiring behind your reverse light. You may need to remove the
interior panel in order to locate. You only need to attach the Camera to ONE of the reverse
lights, not both. If you cannot manually locate the taillight cables, please contact the vehicle
manufacturer or reference a wiring diagram for your vehicle.
5. At your taillight, remove the light bulb socket from the reverse light housing.
6. Determine the reverse light power wires for your car, designating the positive and negative
wires. If you are not sure of which are the power wires, then please contact your vehicle
manufacturer or reference a wiring diagram for your vehicle.
7. Connecting the Camera Power Cable:
a. Take the open wire end of this cable, and connect it to the power wires of your car (as
determined in step 4). Using the Snap Lock Splice Connectors, connect the Camera’s
Red wire to reverse light’s Positive wire. Connect the Camera’s Black Wire to reverse
light’s Negative wire.
b. Use pliers to squeeze the metal tabs of the Snap Lock Splice Connectors and ensure a
solid connection, then snap the plastic cover closed.
8. While sitting in the driver’s seat of the car with the key in the accessory position. The monitor
will automatically start when connected to a power source. If when you place the vehicle in
reverse there is no image, go to the section “Settings and Operation” for more information.
9. Put the vehicle in reverse. If you have a clear picture, put the vehicle back in park and turn the
key to the off position. You are now ready for final steps.