Yada YD-V43 User Manual - page 10
8
8. Plug the attached wire from the Camera into the
Wireless Signal Booster (Part J). Ensure that the
wires are not tangled.
9 You are now ready to test the camera.
10.While sitting in the driver’s seat of the car with the
key in the accessory position, turn on the Rearview
Mirror by pressing the (power) button. The Mirror
will automatically start when connected to a
power source.
11 Put the vehicle in reverse. If you have a clear picture
put the vehicle back in park and turn the key to the
off position. You are now ready for final steps.
12 Take the Wireless Signal Booster (Part J) and using
the double sided Velcro (Part K) attach the box to
the inside of your car.
13 Use the provided cable ties (Part I) to secure wires
neatly within your car.
14.Replace the light socket back into the reverse light
housing.
15 Replace any interior panels which may have been
removed to access the tail light and close your
trunk or rear hatch.
16.Standing with the license plate in one hand and the
camera in the other hand, slide the Camera along
the top of the license plate in order to determine
the placement. Best placement is in the center of
the license plate. If you have a rear hatch handle
you may need to remove the camera bracket,
turn the bracket upside down and reattach to the
camera. You would then mount the camera from
the bottom of the license plate.
17 Peel off the lining to the double sided tape already
attached to the Camera and press firmly to the
license plate to secure the Camera. Make sure the
back of the license plate is clean before attaching
double sided tape.
18.Press the license plate and the Camera mounting
firmly to the car to secure and get full contact
between the license plate and the double sided
tape. Screw the license plate back onto the rear
of your vehicle.
19 Once license plate and Camera are secure, you
can adjust the vertical angle of the camera to your
specific need.
20.As a last check, note the position of the view from
the camera when you place the vehicle in reverse.
Adjust the angle of the camera as necessary to
achieve the best rear view.