Yaesu FTM-3200DR Operating Manual - Basic Operation
14
FTM-3200DR Operating Manual
Basic Operation
Turning the Transceiver ON and OFF
1. To turn the transceiver ON, press and hold in
the
PWR key for 1 second.
2. To turn the transceiver OFF, again press and
hold in the
PWR key for 1 second.
VOL
DIAL
SQL
TXPO
D W
M W
SETUP
REV
D/A
V / M
M H z
You can set the Opening Message to any desired message (up to 8 characters) via Setup
Menu Item “
OPEN MSG 27” see page xx for details.
Inputting the call sign
A screen requesting input of a call sign appears when turning the transceiver on for the
first time, or after resetting the transceiver. The call sign is used to identify the transmitting
station when communicating in digital mode.
1. Press the [
V/M(MW)] key.
2. Rotate the
DIAL knob to select characters,
then press the [
V/M(MW)].
By rotating the
DIAL knob, you can switch
the characters in the following order:
“space” à “-” à “/” à “0” to “9” à “A” to “Z”
r
Up to 10 characters (alphanumeric char-
acters including hyphen) can be entered.
r
“space”, “-”, and “/” are not selectable for
the first character.
Adjusting the Audio Volume Level
Rotate the
VOL knob to adjust the receiver
volume. Clock-wise rotation increases the audio
output level.
VOL
DIAL
SQL
TXPO
D W
M W
SETUP
REV
D/A
V / M
M H z
Adjusting the Squelch Setting
1. Press the [
SQL(TXPO)] key, then rotate the
DAIL knob to select the Squelch level.
2. Press the [
SQL(TXPO)] key again.
Note: A special “RF Squelch” feature is pro-
vided on this radio. This feature allows
you to set the squelch so that only sig-
nals exceeding a certain S-meter lev-
el will open the squelch.
For details,
refer to the Advanced Manual (down-
load from the Yaesu website)
.
VOL
DIAL
SQL
TXPO
D W
M W
SETUP
REV
D/A
V / M
M H z
Application for FCC / IC
FCC ID: K6620523X50 / IC: 511B-20523X50