Yaesu G-5500 User Manual - Pera
18
Elevation Control Commands
These commands are only for az-el operation. Note that an
azimuth angle must always be supplied when changing el-
evation, and that a setting point consists of a pair of angles.
Waaa eee
Turn to aaa degrees azimuth and eee degrees elevation,
where aaa is three digits between “000” and “360 or
450: vary according to controller type,” and eee is three
digits between “000” and “180.” Rotators respond im-
mediately.
Wsss aaa eee aaa sss ...
This command is similar to the [M] command: the first pa-
rameter is a time interval, and succeeding parameters are
angles. With this command, however, angles are in azimuth-
elevation pairs, each pair representing one antenna loca-
tion. At most “1900” pairs can be sent and stored in the
Control Interface. As with the other commands, the time
interval range is limited to “001” to “999” (seconds),
azimuth to “000” to “360 or 450: vary according to
controller type,” and elevation to “000” to “180.”
When this command is sent, the rotators turn to the first
aaa azimuth parameter and the first eee elevation param-
eter, and wait for a subsequent [T] command to begin the
actual stepping (to the next azimuth-elevation pair). Stored
values remain in effect until another [W] command is is-
sued (this may have no parameters, in which case the “? >”
error prompt is returned, but memories are still cleared), or
until the controller is turned off or by toggling the GS-
232A off and on.
O
PERA
TION
C
OMMAND
L
IST