Holdup plus2 safety clip (1x) base (1x) wrench (1x) rear wheel tray assembly (1x) front wheel tray assembly (1x) bolt (1x) lock washer (1x) bolt (8x) lock washer (8x) washer (8x) install this product on 2" hitch version of the holdup pin (1x) plug (1x) key (2x) safety kit included: see additional in...
1034431d-2/21 remove end cap from holdup. Using a flathead screwdriver, remove the end cap from the holdup. Insert plus2 base into holdup. Insert the plus2 base into the holdup tube, aligning holes. Align install main bolt. • insert bolt, and lock- washer in order shown. • tighten with adjustable wr...
1034431d-3/21 attach first tray to base. Lower tray: important: wheel strap is to your right, and pivot arm is to your left. Wheel strap •alignholesintraytobecenteredinslotsonbase. •installbolt,lock-washer,andwasher,inordershown. •fingertightenallfourbolts. •tightenwithsuppliedwrench. Pivot arm 17 f...
Tuck strap into slot at rear of whelltray. Release wheelstrap by pressing the lever on the buckle. Prepare for loading. Caution: if any part of your bike comes in contact with the red trigger, do not use this carrier with that bike. Note: holdup can fold down past horizontal to aid in loading your b...
4x > 1034431d-5/21 if you have bike to bike interference when loading two or more bikes, adjust trays as necessary to eliminate interference between bikes. • loosen the 4 tray bolts (do not remove bolts). • slide the tray left or right. • retighten the 4 tray bolts. • each tray can be adjusted. Rota...
1034431d-6/21 • access locking cables at the end of each pivot arm. • wrap locking cable around bike frame. • insert the pin from the pivot arm into hole at the end of the locking cable. Lock with key. • pushhooksagainsttires. •rearwheelssecuredbyratchetstraps. • besureallhardwareissecuredaccordingt...
