Yale inTouch Installation And Programming Instructions - page 14
14
User Codes can only be programmed through Master Code.
1. Touch the screen with the palm of your hand or fingers to activate
.
2. Enter the 6 digit Master PIN code followed by the
key.
Lock Response: “Menu mode, enter number, press the
key to continue.”
3. Enter "2" followed by the
key.
4. Enter "1" followed by the
key.
5. Enter the User number to be registered (1-255) followed by the
key.
6. Enter a 4-12 digit PIN code for the User number followed by the
key.
7. Press the
key to complete the process and conclude the programming session.
To Set Up User Codes
Press to add more users.
MISCELLANEOUS INFORMATION
Returning the Lock to Factory Defaults
Reset Button
EXT-PWR / REMOTE / MOTOR
EXT-PWR / REMOTE /
MOTOR
7
The outside assembly remains assembled.
1. Remove inside lever with the lever removal tool.
2. Remove battery cover using Allen wrench provided with
lock.
3. Remove four (4) AA alkaline batteries.
4. Remove the 10-32 x 3/4" pan head screw from the center
of the battery housing into the barrel nut of the outside
assembly.
5. Remove inside escutcheon.
6. Reinstall batteries four (4) AA alkaline batteries.
7. On the back of the PC board, push and hold the Reset
Button with the lever removal tool for 3 seconds.
To reassemble the lock, refer to steps 8 through 12 on page 8.
All programming should be returned to factory defaults.
8. Temporarily remove one (1) AA battery (still holding the
reset button in).
9. Reinstall the AA battery (still holding the reset button in).
10. Release reset button and wait 3 seconds.
11. The speaker will announce "Welcome to the Yale Digital
World".
An ASSA ABLOY Group brand
80-9150-0075-010 (08-12)