Yale RH00130S Use, Care And Installation Manual - Installation –
11
Installation –
Mounting the Hood, RH001
1. Measure from range top to hood bottom and mark line A.
_Z`
2. Plum and mark center line.
[ (=_Z<`
\ (!;=_[<`
/_Z`^<\=X
fasten screws all the way. note: wood blocking may
need to be added behind the drywall if no studs are
present. Wall anchors may also be used, check local
codes before using wall anchors.
+"
_/Q$`
Use the third 6 x1-1/4” screw with washer to further
secure the hood to the wall from inside the hood.
8. Center and attach duct cover bracket to wall below
_Z`^
8. Install electrical and duct work. Seal duct work with
aluminum duct tape.
9. Power up hood and check for leaks around duct tape.
10. Place telescopic duct covers onto hood and extend
_`""
_Z`([^
*if using hood in recirculating mode you must secure air
diverter plate onto wall before installing duct work and
duct covers. Turn to page 14 for more details.
A
B
C/L
12
5/16
"
26" min
1
Duct Cover Bracket
3
15/16
”
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
Cable Lock
CAUTION: At least two installers are
required due to the weight and size of the
hood.
!
FIG. A
Cable Lock
_`
be required by local codes. Check with local
requirements and codes, purchase and install
appropriate connector if necessary.
FIG. B