Yamaha Clavinova PF P-100 Owner's Manual - page 12

[REVERB (-1)] button

This button is used to change the reverb type and

depth. It is also used to lower Utility mode and

transpose function settings one step at a time.

[MODULATION (+1)] button

This button lets you change the modulation effect

type and depth. Also, you can use it to raise Utility

mode and transpose function settings one step at a

time.

[EQUALIZER] sliders

These sliders adjust the level of the sound output

by the P-100 in three bands: high, middle, and

low. In Dual and Split modes, the changes you

make will affect both voices being played.

PHONES jack

You can connect a stereo headphone set to the

P-100 using this jack. The speakers

will turn

off automatically when you plug in your head-

phones.

[PITCH] wheel

This wheel bends the pitch of notes you play up or

down, returning automatically to the center posi-

tion when you release it. It also transmits pitch

bend messages to other instruments when MIDI

transmission is enabled. Both voices are bent in

Dual mode. In Split mode, only the main voice is

affected. A Utility mode function lets you change

the pitch bend range to any value within a range of

one octave.

[MODULATION] wheel

This wheel applies a vibrato effect to the notes

you play when you roll it upward. (This effect

does not apply to the two acoustic piano voices.)

It also transmits modulation messages to other

instruments when MIDI transmission is enabled.

Both voices are modulated in Dual mode: only the

main voice is affected in Split mode.

Keyboard

This 88-note Action Effect keyboard simulates the

action and response of an acoustic piano key-

board.

Speakers

The P-100’s two built-in 13 cm speakers each pro-

vide an output of 20 watts. If you wish, you can

turn the speakers off using the SPEAKER switch

on the rear panel.

3