Yamaha Clavinova PF P-100 Owner's Manual - Midi Utility Mode Settings

MIDI UTILITY MODE SETTINGS

MIDI Utility mode

In addition to its Single, Dual, Split, and Demo Play modes, the P-100 has a MIDI Utility mode which allows you to

make a number of settings related to MIDI control functions. Below is a listing of the settings available in this mode:

SETTING DESCRIPTION BUTTONS

Transmit and receive channels MIDI + CHANNEL

Local control on/off MIDI + LOCAL

MIDI merge function on/off

Bulk protect on/off

Pitch bend range

Modulation wheel on/off

CS slider assignment

MIDI + MERGE

MIDI + PROTECT

MIDI + PB

MIDI + MW

MIDI + CS

Foot controller assignment MIDI + FC

Program change transmit table MIDI + PC TRNS

Program change receive table  MIDI + PC RECV

You can enter MIDI Utility mode by pressing the appropriate [VOICE/UTILITY] buttons while holding down the

[MIDI] button.

When you do so, the LEDs above both the [MIDI] button and the [VOICE/UTILITY] button you pressed will begin

blinking, and the current setting for the parameter you selected will appear in the display. You can use either the

[DATA ENTRY] slider or the [-1] and [+l] buttons to change this setting.

When you’ve finished making your settings, press the [MIDI] button once again to exit MIDI Utility mode. Most of

the functions described previously (i.e., the voice selection, tuning

   and transpose functions, etc.) will not work while

the P-100 is in MIDI Utility mode; therefore. you will have to leave this mode in order to use these functions.

31