Yamaha ClickStation CLST-100 Owner's Manual - Precautions
12
● Avoid using your CLICKSTATION in the following
locations to prevent possible damage:
• In direct sunlight or next to heating equipment.
• Extremely cold or hot locations.
• Locations exposed to high humidity or exces-
sive dust.
• Locations subject to strong shocks or vibration.
● Before making any connections, make sure that
the power on the CLICKSTATION and any exter-
nal devices is switched OFF.
● To protect the speaker from possible damage,
always set the VOL. Slider to “0” before switching
the power ON/OFF.
● Do not apply excessive force to the switches and
controls.
● Your Yamaha CLICKSTATION is a precision mu-
sical instrument. Handle it with care and avoid
dropping or bumping it.
● For safety, always remove the power adaptor plug
from the AC wall outlet if there is any danger of
lightning striking in your area.
● Keep the CLICKSTATION away from neon signs
or fluorescent lighting to prevent noise pickup.
● To prevent damage and possibly electrical shock,
never open the case and tamper with the internal
circuitry.
● Never use benzene, thinner or other volatile liq-
uids for cleaning, as these chemicals may cause
damage or discoloration to the finish. Always use
a dry, soft cloth to wipe off dust and dirt.
Precautions
FCC INFORMATION (U.S.A.)
the user’s manual, may cause interference harmful to the operation of
other electronic devices. Compliance with FCC regulations does not
guarantee that interference will not occur in all installations. If this
product is found to be the source of interference, which can be
determined by turning the unit “OFF” and “ON”, please try to
eliminate the problem by using one of the following measures:
Relocate either this product or the device that is being affected by the
interference.
Utilize power outlets that are on different branch (circuit breaker or
fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna.
If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to
co-axial type cable.
If these corrective measures do not produce satisfactory results,
please contact the local retailer authorized to distribute this type of
product. If you cannot locate the appropriate retailer, please contact
Yamaha Corporation of America, Electronic Service Division, 6600
Orangethorpe Ave, Buena Park, CA 90620
1. IMPORTANT NOTICE: DO NOT MODIFY THIS
UNIT!
This product, when installed as indicated in the instructions contained
in this manual, meets FCC requirements. Modifications not expressly
approved by Yamaha may void your authority, granted by the FCC,
to use the product.
2. IMPORTANT:
When connecting this product to accessories and/
or another product use only high-quality shielded cables. Cable/s
supplied with this product MUST be used. Follow all installation
instructions. Failure to follow instructions could void your FCC
authorization to use this product in the USA.
3. NOTE:
This product has been tested and found to comply with the
requirements listed in FCC Regulations, Part 15 for Class “B” digital
devices. Compliance with these requirements provides a reasonable
level of assurance that your use of this product in a residential
environment will not result in harmful interference with other
electronic devices. This equipment generates/uses radio frequencies
and, if not installed and used according to the instructions found in
CANADA
THIS DIGITAL APPARATUS DOES NOT EXCEED THE “CLASS B” LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS SET
OUT IN THE RADIO INTERFERENCE REGULATION OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS.
• This applies only to products distributed by Yamaha Canada Music Ltd.
• The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.