Yamaha CRW2200IX Series Owner's Manual - Set Up The

Setup Procedures

13

Before connecting the CRW2200IX drive and the computer as described below, 

make sure that you have installed appropriate CD writing software (

→

P. 5). If you 

use Windows and if the CD writing software is newly installed, first disconnect all 

IEEE1394 devices from your computer. After properly installing the software, you 

can connect the CRW2200IX drive. For information about how to install the 

software, refer to the documentation that came with it.

If your computer has no built-in IEEE1394 port, you will first need to install an 

IEEE1394 interface card (purchased separately). For information about how to install 

the card, refer to the documentation that came with it.

1

1

1

1

Turn on the computer.

2

2

2

2

Make sure that the power switch on the rear panel of the CRW2200IX 

drive is set to STANDBY.

3

3

3

3

Connect the included AC adapter to the DC-IN connector of the drive 

with the arrow on the adapter plug facing left, as shown below.

Install the CD Writing Software

Set Up the 

CRW2200IX

 Drive

Arrow

DC-IN 

connector

Screw