Yamaha disklavier Mark IV/Pro Series Advanced Operating Manual - page 76

CHAPTER 6: Other Settings

63

If you connect the Disklavier to an audio system, you can 

hear the sound played/played back on the Disklavier from 

the connected audio system, and the sound played back 

on the connected audio system from the Disklavier.

You can select the kind of the incoming/going out audio 

signals. The following options should be set up in 

advance.

[OMNI IN]

Selects the appropriate option to match the incoming data 

input to the [OMNI IN] jacks.

[Audio]:

Select this when you play back an audio 

software on the connected CD player, etc. 

and reproduce the sound from the Monitor 

speakers*.

[Analog MIDI-YM]:

Select this when you play back 

PianoSoft·PlusAudio song.

Note:

 While this option is selected, you 

cannot adjust the [ONMI IN Vol] value, 

and Video Synchronized Playback and 

Vocal Harmony Mode is not available.

[OFF]:

Select this when you cancel the data 

reception from the [OMNI IN] jacks.

[OMNI OUT]

Selects the desired data to be output from the [OMNI 

OUT] jacks.

[Output]: Select this when you output the same audio 

signals as the ones for the Monitor 

speakers*.

[Output+PianoTG]:

Select this when you output the ensemble 

part and the digital piano sound. (Note that 

the digital piano sound is also output in 

Acoustic mode.)

[PianoTG]: Select this when you output only the digital 

piano sound.

[OFF]:

Select this when you cancel the data 

transmission from the [OMNI OUT] jacks.

Hooking Up AV Equipment

DIGITAL

OUT

DIGITAL

OUT

AV amplifier, CD player, etc.

To audio 

inputs

To audio 

outputs

To digital audio 

inputs

RCA cord 

(not 

supplied)

Coaxial digital 

audio cord (not 

supplied)

I/O Center

Setting Up the Disklavier for 

Audio Data Reception/

Transmission