Yamaha EMX3500 Operation Manual - page 10
8
Top Panel
A
B
1
2
3
I/O
O
P
L
R
L
R
L
R
L
R
L
R
A
B
L
R
1L/
MONO
1R
2L/
MONO
2R
1
2
A
B
EFFECT RETURN +4dB
LINE INSERT I/O +4dB
MONITOR OUT +4dB
EFFECT SEND +4dB
CD IN
-6dB
REC OUT
-10dBV
TAPE IN
-10dBV
PRE GEQ
POST GEQ
Q
S
R
T
V
U
Tip : output (send to external device)
TIP-RING-SLEEVE PHONE PLUG
Sleeve :ground
Ring : input (return from external device)
(PHANTOM)
B
A
PAD
GND
GND
S
R
T
-
-
+
+
HA
O Channel input connectors
Each of the EMX3500's input channels is provided with
both a balanced XLR connector (A) and a balanced tip-
ring-sleeve 1/4" phone jack (B). The channel's input
selector switch on the front panel is used to select
between these input connectors. Signal sources that
don't require phantom power should be connected to
the phone jack (B) when the PHANTOM POWER ON/
OFF switch is turned on.
P Channel insert I/O jack
Each input channel has a tip-ring-sleeve 1/4" phone
jack that serves as an insert patch point for the connec-
tion of external signal processing devices or other
equipment between the channel’s head amplifier (the
first amplifier stage after input) and the EQ stage. The
channel insertion point is ideal for the insertion of a
compressors, noise gate, equalizer, or other effect that
needs to be applied to a specific channel only. This
jack accommodates both the send (output) and receive
(input) lines required by the insert point. The signals
are sent and received at a nominal level of +0 dB.
Line
XLR (A)
Phone jack (B)
GROUND
Pin 1
Sleeve
HOT (+)
Pin 2
Tip
COLD (-)
Pin 3
Ring
Phantom Power Warning
To prevent hazard or damage, connect only microphones and cables that
conform to the IEC268-15A standard.