Yamaha KODIAK 450 Owner's Manual - page 157
Other manuals for KODIAK 450:
Owner's Manual
of
190
8-44
EBU12590
Adjusting the rear brake light switch
The rear brake light switch, which is activated
by the brake pedal and rear brake lever, is
properly adjusted when the brake light comes
on just before braking takes effect. If neces-
sary, adjust the brake light switch as follows.
1. Remove panel B. (See page 8-8 for pan-
el removal and installation procedures.)
2. Turn the adjusting nut while holding the
rear brake light switch in place. To make
the brake light come on earlier, turn the
adjusting nut in direction
a. To make the
brake light come on later, turn the adjust-
ing nut in direction
b.
3. Install the panel.
1. Rear brake light switch
2. Adjusting nut
U5ND11.book Page 44 Wednesday, April 30, 2003 1:52 PM