Yamaha MX-A5000 Owner's Manual - page 12
10
En
Advanced speaker configuration
Using a speaker that supports bi-amp connection
If you want to use a speaker that supports bi-amp connection to have more high-quality
sounds, change the CH. SELECTOR setting and connect the speaker to the
corresponding pair of the SPEAKERS terminals.
(Example)
Using a speaker that supports bi-amp connection for CH.2 (R)
By setting the CH. SELECTOR for CH.3 (R) to “CH.2”, CH.2 (R) input signals are output
from both the CH.2 (R) and CH.3 (R) speaker terminals. In this case, CH.3 (R) input is
not used.
Using two pairs of front speakers (SPEAKERS A/B)
If you connect two pairs of front speakers to the CH.2 A/B terminals, you can switch the
front speakers to be used by pressing SPEAKERS A/B on the front panel of the unit.
• When using two pairs of the speakers connected to the CH.2 A/B terminals at the same time, be sure to
use 8-ohm speakers and set IMPEDANCE SELECTOR to the upper position (p.7).
Using three speakers for one channel (multi-speaker)
If you want to use three speakers for reproducing CH.1 audio signals (such as center
channel signals), change the CH. SELECTOR setting and connect the speakers to the
CH.1 and CH.4 (L/R) terminals.
Advanced speaker configuration
Caution
• Remove the unit’s power cable from an AC wall outlet before making any connections or operating the
switches.
Caution
• Before making bi-amp connections, remove any brackets or cables that connect a woofer with a
tweeter. Refer to the instruction manual of the speakers for details. If you are not making bi-amp
connections, make sure that the brackets or cables are connected before connecting the speaker
cables.
R
R
SPEAKERS
TRIGGER
+12V
IN
THROUGH
OUT
BAL.
UNBAL.
AUTO POWER
STANDBY
IMPEDANCE
SELECTOR
SELECTEUR
D’IMPEDANCE
OUT
OFF
ON
CH.6
CH.5
CH.5
CH.4
CH.3
CH.2
B
CH.2
A
CH.1
12V
0.1A
R
BAL.
UNBAL.
CH.2
R
BAL.
UNBAL.
CH.6
CH. SELECTOR
CH.5
CH.6
R
BAL.
UNBAL.
CH.3
CH. SELECTOR
CH.2
CH.3
CH
CH. SE
CH.1
R
CH.3
CH. SELECTOR
CH.2
CH.3
The unit (rear)
Input from pre-amplifier
CH.2 A (R) and
CH.3 (R) terminals
Set CH. SELECTOR
for CH.3 (R) to “CH.2”
CH.2
B
CH.2
A
CH.2
B
CH.2
A
The unit (rear)
CH.2 A/B (L)
terminals
CH.2 A/B (R)
terminals
CH.4
CH.2
CH.4
BAL.
UNBAL.
CH.1
R
CH.4
CH. SELECTOR
CH.1
CH.4
L
CH.4
CH. SELECTOR
CH.1
CH.4
The unit (rear)
Set CH. SELECTOR
for CH.4 (R) and
CH.4 (L) to “CH.1”
Input from pre-amplifier
CH.4 (R)
terminal
CH.4 (L)
terminal
CH.1
terminal
MX-A5000_om_UCTKABGLVF.book Page 10 Thursday, April 4, 2013 5:28 PM