Yamaha MX-A5000 Owner's Manual - page 7
Part names and functions
En
5
7
INPUT (XLR) jack
For connecting to a pre-amplifier with XLR output jacks (p.6).
To use the XLR jack, set the corresponding BAL/UNBAL
switch to “BAL”.
When connecting an XLR balanced cable, match the pins
and insert the “male” connector of the cable until you hear a
click.
• When disconnecting the cable from the unit, hold down the PUSH
button on the unit and then pull the connector out.
8
INPUT (RCA) jack
For connecting to a pre-amplifier with RCA output jacks
(p.6).
To use the RCA jack, set the corresponding BAL/UNBAL
switch to “UNBAL”.
• Remove the RCA short pins attached to the INPUT (RCA) jacks
before making connections. Be sure to keep them in a place
inaccessible to small children who may accidentally swallow
small parts.
• To protect against noise contamination, we recommend
attaching the RCA short pins when the INPUT (RCA) jacks are
not in use.
9
BAL/UNBAL switch
Switches between XLR input and RCA input for each channel
(p.6).
About the XLR jacks
• The pin assignments for the XLR jacks of the unit are shown
below. Before connecting an XLR balanced cable, refer to the
instruction manual of your pre-amplifier and verify that its XLR
output jacks are compatible with the pin assignments.
BA
L.
UNB
AL.
XLR balanced cable (male)
3. COLD
2. HOT
1. GND
BAL.
UNBA
L.
RCA cable
RCA short pin
MX-A5000_om_UCTKABGLVF.book Page 5 Thursday, April 4, 2013 5:28 PM