Yamaha WaveRunner VX110 Deluxe Assembly Manual - page 18
– 14 –
E
• Make sure that engine has enough oil
but do not overfill. If there is too little
oil, the engine can be damaged. If there
is too much oil, the air filter can
become saturated with oil, perma-
nently damaging the filter and reduc-
ing engine performance. Follow the
checking procedure carefully.
• Make sure that debris or water does
not enter the oil tank filler hole. Debris
or water in the engine oil can cause
serious engine damage.
• Place the watercraft in a horizontal posi-
tion or launch the watercraft.
• Remove the seat.
• Remove the oil filler cap
1 and check for
oil on the dipstick
2.
• If there is no oil on the dipstick, pour
enough oil so that the tip of the dipstick
comes into contact with the oil, and then
install the filler cap.
• Start the engine.
CAUTION:
When starting the engine make sure the
dipstick is securely fitted into the oil
tank.
NOTE:
• The engine cannot be started if the
Yamaha Security System is in the lock
mode.
• For information on the Yamaha Security
System, see the owner’s manual.
• Run the engine at trolling speed for 6
minutes or more, and then stop the
engine.
CAUTION:
When checking the oil level on land, be
sure to connect a garden hose to the
watercraft for proper water supply.