Z-BEN D700 Series User Manual - page 14
2、Cruise between Points
Multiple preset points connected cruise lines, call cruise between points, the PTZ run around on the line
1)Cruise Between Points Settings
Cruise lines is connected by multiple preset points, setting procedure is as follows:
Step 1: In Picture 3.10, the Direction key will turn PTZ to designated location , click Settings button to enter Picture 3.13,
Step 2: click Cruise buttons, the write proper value into the Cruise Line and Preset Points blank,then click Add Preset Points button,
Complete setting (also can add and delete cruise line which has been set up)
Step 3: repeat step1 and step2 , until set out all the preset designated cruise lines。
Remove Preset:Please input preset value in the blank, click Remove Preset button, then remove the preset points.
Remove Cruise Line:Input the number of cruise line, click Remove Cruise Lines button, then remove the cruise lines set。
2)The Calls of Cruise between Points
In Picture 3.10, click Page Shift button, enter PTZ control menu as shown in Picture 3.12. Please input the number of cruise in the
value blank, then click Cruise between Points button, PTZ begins to work on the cruise line. Click Stop button to stop cruise.
Picture 3.13 Cruise Between Points Settings Picture 3.14 Scan Setup
3、Scan
PTZ also can work on the preset scan line repeatedly.
1)Scan setup
Step1:In Picture 3.10, click Setup button ,enter Picture 3.14;
Step2:Click Scan button,the input proper value in the scan value blank;
Step3:Click Start button, enter Picture3.10,here you can set the following items: Zoom、Focus、Aperture、Direction and
So on. Click Setup button to go back Picture 3.14;
Step4:Click End button to complete setup。Click the right button of the mouse to exit.
2)Scan Calls
In Picture 3.10, click Page Shift button, then enter PTZ control menu as shown in Picture 3.12. Please input the number of scan in the
value blank , then click Scan button,PTZ begins to work on the scan line . Click Stop button to stop.
Network Hard Disk Videocorder Fast Operation manual
13