Z-Com ZCN-1523H-5-16 Quick Installation Manual - Chapter 5 Troubleshooting
Chapter 5
Troubleshooting
Page 18
Chapter 5 Troubleshooting
1.
Why can’t I go to the log-in page, while I key in 192.168.1.1 in the address bar of the
web browser?
A: Make sure that the CPE is correctly connected with you PC, and powered on already.
Then make sure that the IP address of your PC is set in the same network segment with
the CPE, which means that the IP address of your PC should be between 192.168.1.2
and 192.168.1.255.
2.
In the CPE mode, the quality of the connection is bad or unstable after choosing an
available access point to connect to. How can I solve it?
A: Since the CPE comes with the built-in directional antenna, you should turn the unit to
face the direction where the access point you connect to is located to get the best quality
of the connection. In addition, you can also click
Site Survey in the “Wireless Basic
Settings” window to see the Signal Strength. If it is weak or unstable (the smaller the
number is, the weaker the signal strength is; please note that the signal strength comes
with a native sign with the numbers.), please choose another available access point or
router for better connection.