Z Corporation Spectrum Z 510 Maintenance Manual - page 2
85063 Spectrum Z510 Preventative Maintenance Procedure 2/12
1.Fast Axis Module
Document #s/Notes
Clean rails
Clean Bumpers
Clean Pulleys with dental pick
Careful not to scratch the metal
Grease Fast Axis
Check Fast Axis for smoothness
Reset maintenance reminder
Clean Pogo Card
Check Pogo Pins for springiness
Clean alignment window (inside and out)
Clean pogo pins, connector and LED
Clean roller
Clean Snowplows
Replace scraper blade
Replace Septa
See instructions
Replace front rail pad (anti-rotate bearing)
2.Slow Axis Rails
Document #s/Notes
Clean rails
Clean pulleys with dental pick
Grease slow axis bearings
Check axis for smoothness
Reset maintenance reminder
User Manual
3.Powder Handling/ZD5
Document #s/Notes
Check heater for proper function
Use pre-heat in Service Menu
Blow powder out of heater
Compressed air
Clean deck of 510
Check air gun for proper function
Check Air Filter desiccant
Red means it needs changed
Check user vacuum hose
Clean powder build up in cabinet
Check compressor vibration mounts
Check vacuum while de-powdering
4.Service Station
Document #s/Notes
Replace squeegee
See instructions
Clean squirter block
See instructions
Clean base of Service Station
Clean out drain catch
Check squirter for proper function
Add ZC5 if necessary
5.Binder
Document #s/Notes
Perform fluids cleanout procedure
09847 SB47 fluids System Cleanout procedure
Check for leaks at binder tank
Visual inspection
Check for leaks at luer fittings
Visual inspection
Check flow rate at septum
Check for air bubbles
Visual inspection
Check purge time
Check temperatures while purging
Change binder tank in-line filters
Pull hoses off with pliers and insert new filters