1. DL manuals
  2. Z Corporation
  3. 3D Printers
  4. ZPrinter 310
  5. Troubleshooting Manual

Z Corporation ZPrinter 310 Troubleshooting Manual

Other manuals for ZPrinter 310: User Manual

Summary of ZPrinter 310

  • Page 1

    08634 z z p p r r i i n n t t e e r r ® ® 3 3 1 1 0 0 troubleshooting guide rev b revision history: rev 06: jpk 1/6/2003 unreleased revision rev a: jpk 2/24/2003 released rev b: brs 8/12/04 revised ecn 1323 z, zp, zb, zprinter, zcast and the z corp. Logo are trademarks of z corporation. Information ...

  • Page 2

    Symptom cause / problem likelihood + high - low solution print head failure + replace print head binder bottle not plugged into top cover + check connection to binder bottle out of binder + refill binder bottle and bleed fluid system (see users manual chapter 6) air in fluid system - bleed fluid sys...

  • Page 3

    Print head not seated correctly + re-seat pen and restart build pogo pin / pins are bent or broken - change pogo card (see 08632 benchwork manual) head card ribbon cable disconnected at either end - check head card ribbon cable connections error 1002 message (rom read failed for head) tape still in ...

  • Page 4

    Low on fast axis oil + oil fast axis felt washers (see users manual) fast axis motor cable not properly connected at the head card + check fast axis plug connection debris in fast axis bearings + inspect fast axis bearings and clean or replace if necessary fast axis belt too tight + adjust belt to p...

  • Page 5

    Waste bottle not installed / halfway installed to valve at front panel + check connection at waste bottle mount waste tube clogged - unclog or replace waste tube waste bottle vent clogged - check and unclog cap vent or replace cap service station overflowing waste bottle not plugged in properly + ch...

  • Page 6

    Print head failing + replace print head incorrect saturation setting + set correct saturation for powder /binder system being used wrong binder being used + replace binder with correct formula user recycled binder - replace binder with correct formula parts weak, crumbly, wet or caked with powder po...

  • Page 7

    Fast axis belt skipping teeth / chattering fast axis belt too loose + tighten fast axis belt to proper tension can’t find printer on network poor ethernet connection or improper setup + see 08606 ethernet setup procedure for instructions service station out of cleaning fluid + fill cleaning fluid re...