Z Microsystems ZX1 User Manual - page 7
Issued: 01/21/10 REV 50
Doc# 27-0042UM
12
13
Issued: 01/21/10 REV 50
Doc# 27-0042UM
REMOVING/INSTALLING MEMORY DIMM
1. E a c h o f t h e M e m o r y D I M M s l o t s
i s e quipp e d w it h l o c k ing latc he s to
se c ure the Memor y DIMM in place.
3 . Inst all the new M emor y DI M M by
carefully aligning the Memor y DIMM
parallel to the slot and then gently, but
firmly inserting.
4. Carefully push the Memory DIMM in
using your thumbs.
4. Secure the Memor y D I M M i n t o t h e
s l o t b y p u l l i n g t h e l o c k i n g l a t c h e s
towards the Memory DIMM.
2. Use your fingers to push the locking
latches away from the existing Memory
DIMM. Gently remove the Memory DIMM
from its slot
OPERATIONS
RE-INSTALLING TOP COVER OF ZX1 STATION
1. Place cover loosely onto ZX1 station.
When placed on the station, make sure
your side flanges properly align with the
corresponding slots.
3. When the top is firmly seated onto the
station casing, turn the attachment screws
at the rear of the top cover to secure .
2. Using one thumb push slightly down
on the front edge of the top and the other
hand to push the top cover from the rear
or the unit.
OPERATIONS