Z Microsystems ZX1 User Manual - page 9
Issued: 01/21/10 REV 50
Doc# 27-0042UM
16
17
Issued: 01/21/10 REV 50
Doc# 27-0042UM
REMOVING THE LOCKABLE FACE PLATE COVER
1. Using the provided key, tur n to the
r ight to unloc k the fac e plate c over.
3. Pull the right side of the face plate cover
away from the right support bracket and
lift away from the ZX1 unit.
2. Release the at tachment screws on
either side of the face plate cover. You
may either twist the fastening screw with
fingers or use a Flathead screwdriver.
OPERATIONS
NOTE:
The Lockable Face Plate
Cover is an option available only
to certain models.
INSTALLING THE LOCKABLE FACE PLATE COVER
1. The face plate cover has small fl anges
on the left side that per fectly fit within
corresponding slots on the left support
bracket.
3. Align the fl anges on the left side of the
face plate cover with their corresponding
slots on the left support bracket.
4. When the left flanges are secured in
the support bracket, position the right side
of the face fl at cover onto its corresponding
support bracket.
5. W hen b ot h si de s are se c ure d o nto
their respective suppor t brackets, turn
the key to lock the face plate cover.
2. The corresponding slots on the support
bracket are displayed above.
OPERATIONS