Z-Wave IM20 User Manual - page 3
3
d)
Put the main body on the hanging panel, align the downside of main body at the underneath location hole of
hanging panel, pull down to fix the main body.
e)
Put the magnet on the magnet hanging panel, align the downside of magnet at the underneath location hole
of hanging panel, pull down to fix the magnet
4. Foam Rubber Adhesive Fixing
a) Take out the rubber foam from PE bag.
b) Tear off one side release paper from rubber foam; stick them to the back side of main body & magnet
respectively.
c) Make location holes by scribing lines on the fixed or movable door/window in parallel, the distance for main
body and magnet: ≤6MM.
d) Tear off remaining rubber foam release paper on the main body and magnet; stick them to the fixed or
movable door/window.
IV. IM20-ZWAVE Operation Instruction
1. ZWAVE basic operations
1.1 Wireless network registration and delete
a)
Network register: Activate the master gateway into register status, please press the anti-tamper switch 3 times
repeatedly within 1.5 seconds to register, the right LED indicator blinking in the process and turns off LED
indicator if registration completed.
b) Network delete: Activate the master gateway into delete status, please press the anti- tamper switch 3 times
repeatedly in 1.5 seconds to delete.