Z-Wave RPB11647BSB User manual - Warnings And Cautions
2
WARNINGS AND CAUTIONS
Switch the main power off when installing Z-wave products.
Do not exceed current 16 Amp at all times.
Do not disassemble the outlet.
Switches are not guaranteed to remotely operate in certain circumstances such as radio
shadow area.
Z-wave enabled devices should never be used to supply power to, or control the On/Off
status of medical and/or life support equipment.
Do not install the products outdoors and/or humid environment
INSTALLATION
A
Holl for Push Button
E
Wall Connection screw hole
B
Push Button
F
Hot (red)
C
LED indicator
G
Neutral (black)
D
Case coupling hole
H
Ground (green)
1. Shut off power to the circuit at circuit breaker or fuse box.
※ Warning: Verify power is OFF to switch box before continuing.
2. Remove wall plate.
3. Remove the outlet mounting screws.
4. Carefully remove the outlet from the outlet box
5. Disconnect the wires from the existing outlet.
6. There are three wires on the P-M-O. Match these to the wires on wall.
7. Fix the P-M-O to the wall and fasten the screw.
8. Place the case on the product.