Z-Wave WSR 1706 V 1.0 User Manual - page 17
16
2)
Confirm the dialog. This will perform a factory reset and remove every Z-Wave device from
your Gateway (you have to repair them again).
Note: If this controller is the primary controller for your network, resetting it will result in the nodes
in your network being orphaned and it will be necessary after the reset to exclude and re-include all
of the nodes in the network. If this controller is being used as a secondary controller in the network,
use this procedure to reset this controller only in the event that the network primary controller is
missing or otherwise inoperable.
Command Class support
Basic Command Class Support
The Gateway does not map the Basic Command Class to any functionality. It ignores Basic Get
requests.
Basic CC is supported but the device won't perform any further action upon receiving any commands
of such class.
Association Command Class Support
The Gateway supports Association Command Class. It has one association group ("Lifeline" group),
only one device can be associated to this group. The Gateway will send reset notifications to the
associated device when the Gateway is factory reset.
Security Command Class Support
Your Gateway is a security-enabled device. When a security-enabled Z-Wave device is added to the
Gateway’s network, its secure communication will be 128-bit AES encrypted.
Command classes
Supported command classes
Application Status Command Class, Version 1
RESET
CANCEL