Z-Wave ZWN-BPC Installation Instructions
- 01-
-03-
-02-
FEATURE
ZWN-BPC
SPECIFICATIONS
PIR Motion Sensor
INSTALLATION INSTRUCTIONS
Ceiling Mounted
Power Supply...................................................................2AA batteries
RF Range......................................Up to 131 feet line of sight between
Z-Wave Frequency..................................................... 908.42MHz(US)
Operation Temperature...........................................................32-104°F
DESCRIPTION
Adopt wireless RF technology
Support Z-Wave associations, sending commands up to 5 associated
Place of PIR Motion Sensor:
It is very important to place the sensor with 6-7 feet from the primary
location, at least 8 feet away from the possible false triggering area.
Hotel Room :
Private Office :
8 to 9 feet
At least 2 feet
8 to 9 feet
7 feet
Air Vent
Bath Room
At least 8 feet
Air-conditioner
Sitting Spot, a Chair or a Coach
PIR Motion Sensor
At least 7 feet
6-7 feet
6-7 feet
PLACEMENT
INSTALLATION
1.The PIR Motion Sensor consists of two parts: Attachment Base and
2.Place Attachment Base on ceiling by using both screws and adhesive pad.
3.Insert the two AA batteries noting the proper orientation.
4.Lock the Motion Sensor by twisting onto the base.
Motion Sensor.
Ceiling
Adhesive Pad
Attachment Base
Motion Sensor
Screw
The PIR Motion Sensor ZWN-BPC is a Z-Wave enabled device and is
This sensor acts as a security device by detecting changes in infrared
fully compatible with other Z-Wave certified device from other manufacturers
with the ZWN-BDS to monitor the environment and provide hand-free
lighting control, it can also trigger a Z-Wave enabled alarm when motion
radiation levels. when some body moves within or across the detection
of coverage, one triggering signal will be transmitted to associated
PIR Sensitivity Adjustment...................................25%/50%/75%/100%
PIR Detection Coverage..................................................... Up to 600ft
2
The ZWN-BPC provides a 360° coverage pattern, up to 600 square
feet. The coverage shown represents walking motion at a mounting
height of 8 feet( See Figure 1 ). For building spaces with lower levels
26ft
8m
8 ft
13 ft 13 ft
7 ft
7 ft
3 ft 0
3 ft
Typical
desk-top
level
Figure 1
of activity or with obstacles and barriers, coverage size may decrease.
Adjustable PIR Sensitivity
Test Mode...................................................................................15 sec.
LED motion indicator
PIR Motion Sensor
ADJUSTMENT
Adjustable: 25%/50%/75%/100%
Sensor Sensitivity Range
Program Button
Figure 2
Figure 3
Figure 4
COVERAGE PATTERN
DIP Switch
DIP Switch
PIR Sensitivity
25%
50%
75%
100%
Z-Wave devices
is detected.
Z-Wave devices.
360 degree ceiling mounted cover up to 600ft
2
For indoor use only
Low battery detection
the Wireless Controller and the closest Z-Wave receiver module.
Adding to Z-Wave network
At the back of Motion Sensor, there is a program button which is used
OPERATION
to add/remove and associated with other Z-Wave devices.
and/or other applications. This device is typically used in conjunction