User’s manual vf3000a http://www.Zalman.Com ver. 1.1 to ensure safe and easy installation, please read the following precautions. Ati radeon hd 5830 ati radeon hd 5850 ati radeon hd 5870
1 .Com 1. Precautions 2. Specifications 1) this cooler is specifically optimized and designed for reference vga cards ati radeon hd5830, hd5850 and hd5870. 2) by installing this product on a vga (video graphics array) card, two pci slots immediately below the pcie (or agp) slot occupied by the vf3000a...
2 .Com 3. Components user’s manual vf3000 a vga ram heatsink (a type × 1, b type × 7) a type b type thermal grease [zm-stg2m] pvc washers × 6 nipples × 4 rubber rings × 4 springs × 4 fixing nuts × 4 fet heatsink rubber washers × 3 fixing pins × 3 fan mate 2 cable fan mate 2 double-sided tape.
3 .Com 4. Exploded view vga cooler fet heatsink fixing pin rubber washer ram heatsink(a type) ram heatsink(b type) nipple rubber ring vga ram vga chipset pvc washer spring fixing nut.
4 .Com 1) vga ram heatsink attachment 2) fet heatsink installation remove the film from the thermal tapes on the bottom of the ram heatsinks and attach the heatsinks to the vga ram. For a type ram heatsink, please attach to both the ram and fet. Fet ram ① remove the double-sided tape covers from the ...
5 .Com ③ please remove the sticker’s lamination from the fet heatsink’s rubber washers and install to the vga card using the fixing pins. Radeon hd5850 (use 3 fixing pins) radeon hd5870 (use 2 fixing pins) 3) thermal grease application clean the contact surface of the vga chipset completely. Apply a...
6 .Com 4) nipple/rubber ring installation fasten the nipples and rubber rings to the vga cooler’s fixing guide. Nipple rubber ring 5) cooler installation after installing the nipples and rubber rings to the cooler, mount the cooler to the vga card. 6) cooler fastening with the cooler’s bottom facing...
7 .Com ▶ please tighten each of the 4 fixing nuts one rotation at a time until all are completely tightened. ※ completely fastening one nut at a time can cause damage to the vga chipset. ▶ make sure the cooler base is installed in full adhesion with the vga chipset. ▶ make sure there is no physical ...
8 .Com 2) fan mate 2 operation adjust the desired rpm setting by moving the fan speed control knob left or right. Fan speed control knob.
Ati hd5830 user’s manual vga cooler ram heatsink (a) ram heatsink (b) nipple rubber ring vga ram vga chipset pvc washer spring fixing nut ▶ this manual is for reference vga card hd5830 users. ▶ when installing the vf3000a on the hd5830, the fet heatsinks are not used. ▶ the installation location of ...
