ZALMAN CNPS7000B-AlCu User Manual - page 5
※
The specifications of any product may change without prior notice to improve performance.
4
3) AMD Sempron / AMD64 - Socket 754/939/940
All CPUs conforming to Socket 754/939/940 platform
Cautions )
① No motherboard components with a height greater than 39mm, as
well as the PSU, disk drives, VGA card, and RAM should be present
within a 55mm radius from the center of the CPU.
② For more information, please visit the Zalman website and refer to
“CNPS7000(A/B) Compatible Socket 754/939/940 Motherboards
List
”link.
1) Apply Thermal Grease
Clean off particles and residue then spread a thin layer of
thermal grease on the CPU.
2) Install Clip Supports for Socket 478
Install the clip supports for socket 478 on both sides of
the retention guide as shown in the diagram.
3) Insert Bolts
Insert the two bolts into the inner holes of the clip.
4) Place FHS
Set the FHS at the center of the CPU. Screw the bolts in
slightly, then tighten each bolt a few turns at a time while
alternating between the two until the clip supports are
completely pressed against the clip.
7. Installation (Intel Pentium 4 - 478)
5) Connect Power (How to use FAN MATE 2)
◆
Please refer to FAN MATE 2 Installation and Usage on page 7.
FHS
Clip Support for
Socket 478
Bolt
Inner Hole
Clip
Retention Guide
Clip Support for Socket 478
CPU (IHS)
Thermal Grease
①