ZALMAN CNPS7000B-AlCu User Manual - page 7
※
The specifications of any product may change without prior notice to improve performance.
6
1) Fasten Nipples
Place a small washer on the motherboard. Then, put a nipple over it and fasten the nipple until the
Backplate for AMD64 is firmly attached to the motherboard on the opposite side of the CPU.
* A Retention Guide is not necessary for installing CNPS7000B on Socket 754/939/940.
3) Insert Bolts
Insert the two bolts into the outer holes of the clip.
4) Place FHS
Set the FHS at the center of the CPU. Screw the
bolts in slightly, then tighten each bolt a few turns at a
time while alternating between the two until the nipples
are completely pressed against the clip.
9. Installation (AMD Sempron / AMD64 - 754/939/940)
5) Connect Power (How to use FAN MATE 2)
◆
Please refer to FAN MATE 2 Installation and Usage on page 7.
2) Apply Thermal Grease
Clean off particles and residue then spread a thin layer of
thermal grease on the CPU.
FHS
Nipple
Bolt
Outer Hole
Clip
CPU (Lid)
Thermal Grease
Backplate for AMD64
Nipple
Motherboard
Small Washer