ZALMAN CNPS7000B User Manual - page 6
※
The specifications of any product may change without prior notice to improve performance.
5
1) Install Clip Supports for Socket 462
Install the clip supports for socket 462 on the motherboard. Make sure to place A-type (blue : installed
near the lever) and B-type (white) supports at the appropriate location.
The installation should be done in the order of : bolts > small washers > motherboard > small washers >
clip supports (see below).
2) Apply Thermal Grease
Clean off particles and residue and then spread the
included thermal grease thinly and evenly over the CPU
core that touches the FHS surface.
8. Installation (AMD Duron / Athlon / Athlon XP - 462)
5) Supply Power (Connect FAN MATE 2)
◆
Please refer to FAN MATE 2 Installation and Usage on page 7.
CPU
Thermal Grease
Bolt
Inner Hole
Clip
FHS
Cilp Support for
Socket 462
3) Insert Bolts
Insert the two bolts into the inner holes of the clip.
4) Place FHS
Set the FHS at the center of the CPU. Screw the
bolts in slightly, and then tighten them in an alternating
fashion until the clip supports are completely pressed
against the clip.
Clip Support B for Socket 462 (White)
Lever
Small Washer
Motherboard
Small Washer
Bolt
Clip Support B for Socket 462 (White)
Clip Support A for
Socket 462 (Blue)